Hi Winton,
Winton Roseland wrote:
Eth0 and sit0 are the new device. If I boot with the
So, it looks like the device drivers are now working properly...
I am not very knowlegdable of network set-ups, but
what I would like is:
$ man 5 interfaces
It appears that your device works, and you now need to configure it in
/etc/network/interfaces.
1) When the cable is pluggedinto either device, that
the ip address is the same. I know I can't do taht
and have both devices plugged in.
Autoconfiguring each device is something done on Knoppix, but is rare on
a typical hard drive installation. Get the device working first.
There's info in the man page about different network profiles.
How can I configure this so that it works?
You did a great job doing your homework on the kernel patch. Don't give
up now! :-)
Peace,
Gabriel
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
