> hy *,
>
> i am refering to a post from july 2005 in debian-user ("Debian Installer
> SATA detection").
>
> i, too, have a shuttle st20g5 barebone which comes with a uli 1573 chipset
> (which itself runs a uli 5287 sata controller). the website of uli
> provides
> information about how to install the sata-controller (look for the driver
> for the m1573 chipset): actually it boils down to compile the kernel with
> the sata_uli driver, which is shipped with the kernel (since about
> 2.6.10).
>
> the debian testing netinstall which i recently downloaded (kernel version
> 2.6.12 so it seems) is not able to recognize the sata controller => no
> sata-drive => no hdd partitioning => no installation => :-(
> (...)
some minutes ago i have successfull installed debian on my sata-hdd-system.
the solution was attaching a jumper at the back of the hdd (the samsung
manual talks about a "speed limit jumper"). after this jumper has been
placed, the hdd is not listed (as ide) in the bios anymore - i guess that's
the "compatible mode" which i have deactivated this way.
at the debian installer (no matter if "linux" or "expert"), i manually have
to load the ahci and sata_uli modules, before i can continue installation.
but fixing this problem ends up in another one occuring: after the
installation has finished (i.e. after the FIRST reboot), the system does not
boot anymore. here i have two "options":
1) leave the jumper (mentioned above) attached at the hdd: not even grub
starts up and the computer complains about not system found
2) i remove the jumper (hdd appears again in the bios as "ide"), grub starts
up and loads the kernel. BUT: i get a kernel panic when the kernel tries to
load the sata modules:
"not syncing - attempting to kill init".
has anyone some ideas?
mila
--
Telefonieren Sie schon oder sparen Sie noch?
NEU: GMX Phone_Flat http://www.gmx.net/de/go/telefonie
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
