Hi,
Since I updated to 2.6.14-1-686, hda is in PIO mode, and when I do
hdparm -d1 /dev/hda i get "HDIO_SET_DMA failed: Operation not permitted".
Im using the default kernel in the debian sid repositories, version
2.6.14-1-686.
It is working fine in 2.6.12-686.
Any ideas?
Thanks in advance.
Ricardo Teixeira.
$ sudo hdparm /dev/hda
/dev/hda:
multcount = 0 (off)
IO_support = 1 (32-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 256 (on)
geometry = 65535/16/63, sectors = 156301488, start = 0
$ sudo hdparm -i /dev/hda
/dev/hda:
Model=TOSHIBA MK8025GAS, FwRev=KA023A, SerialNo=63EP0131T
Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=48
BuffType=unknown, BuffSize=0kB, MaxMultSect=16, MultSect=off
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=156301488
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: sdma0 sdma1 sdma2 mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5
AdvancedPM=yes: unknown setting WriteCache=enabled
Drive conforms to: device does not report version:
* signifies the current active mode
--------------------------------------------
I also got these errors in dmesg:
(...)
hda: status error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
hda: drive not ready for command
hda: CHECK for good STATUS
(...)
ICH4: chipset revision 3
ICH4: not 100% native mode: will probe irqs later
ICH4: port 0x01f0 already claimed by ide0
ICH4: port 0x0170 already claimed by ide1
ICH4: neither IDE port enabled (BIOS)
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
