I'm experiencing some trouble with my DSL setup.
Every time after reboot my routing table is using my ppp0 P-t-P address
instead of its inet address.
$ ifconfig ppp0
ppp0 Link encap:Point-to-Point Protocol
inet addr:168.100.249.107 P-t-P:168.100.250.1
Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:278715 errors:0 dropped:0 overruns:0 frame:0
TX packets:280248 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:155755125 (148.5 MiB) TX bytes:67529994 (64.4 MiB)
$ route -e
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
168.100.250.1 * 255.255.255.255 UH 0 0 0 ppp0
192.168.2.0 * 255.255.255.0 U 0 0 0
eth0
192.168.1.0 * 255.255.255.0 U 0 0 0
eth1
default 168.100.250.1 0.0.0.0 UG 0 0 0 ppp0
I'm not getting any Internet connection by using the P-t-P address.
Only after I delete PPP0 and default gateway route and change them
manually to the PPP0 inet address I get the desired connection.
When I change the routing addresses from 168.100.250.1 to
168.100.249.107 I get:
$ route -e
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
249-107.custome * 255.255.255.255 UH 0 0 0
ppp0
192.168.2.0 * 255.255.255.0 U 0 0 0
eth0
192.168.1.0 * 255.255.255.0 U 0 0 0
eth1
default 249-107.custome 0.0.0.0 UG 0 0 0
ppp0
And everything works fine from here.
Is there something with my configuration messed up and I should get a
proper connection through the P-t-P address?
Or is there a way to tell my system it should use the external address
instead?
Thanks for any help,
-- Bernd
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
