>> Has anyone had a similar problem. >> >> While I was under 2.2 kernel my scsi tape drive worked fine. After >> upgrading to 2.4, however, I can't seem to get it to install or detect >> my scsi drive no matter what. Any ideas? >> >> Curtis >> >> -- >> To UNSUBSCRIBE, email to [EMAIL PROTECTED] >> with a subject of unsubscribe. Trouble? Contact [EMAIL PROTECTED] > >What's your SCSI I/F H/W? > >It's a shot in the dark, but... >When I upgraded to 2.4.17 tar started hanging my system. It turned out that >SCSI disconnects aren't supported for the external SCSI on the Mac 8500. >Things >worked fine when backing up the internal disks, but the system hung when >backing >up the outboard disks. A workaround was to reconfigure--I put all disks on the >internal SCSI and isolatied the tape drive on the external SCSI. > >--rich >
Some more detail would probably be useful. Here are some pointer that helped me install an old Conner Peregrine CTD4004 SCSI DAT Drive on to my Woody box (Compaq Professional Workstation 5000 PPro SMP) kernel 2.4.7. *Make sure that SCSI tape support is compiled into your kernel. *Even if this support is compiled in run dmesg | more after reboot and see if you can spot something like the following: Vendor: ARCHIVE Model: Python 28388-XXX Rev: 5.45 Type: Sequential-Access ANSI SCSI revision: 02 (Sequential-Access is the important bit) Followed by: Attached scsi tape st0 at scsi0, channel 0, id 4, lun 0 *Switch off any power on self diagnostic/fault testing routine. Hope this helps. James James Aitken W: +44 (0) 20 8547 0470 H: +44 (0) 1322 404582 M: +44 (0) 7768 057306 E: [EMAIL PROTECTED] -- Personalised email by http://another.com
