> lee wrote: > >Hi folks, > > > >I enter this post as my last ditch effort to get debian (2. 2r4) going > > here. I m installing the binary cd's. All goes well up to the x install, > > whereby I get the message "transSocket unix connect cannot connect ernno > > 111" This will repeat over and over till I finally tire and have to do a > > crtl-alt-del. Upon reboot x cannot be found (as it wasn't installed). > > > >I've tried with a number of diff video cards agp and pci,numerous settings > > in the bios. Searched in the documentation,and am really at a loss as to > > what to do now. > > > >I'm doing the advanced install,and am left with no dependancy problems > > from what I can see. > > > >Are there any suggestions as to how to handle this issue ? Thank you all > > very much for your time,and any starters that may help me overcome this. > > > >Lee > > Hi there, > You don't provide a whole lot of info... ;) What are you running? > Potato? Woody? And what videocard have you in your box? To start > somewhere, briefly describe what you have done so far. > > Pontus
You're right Pontus,,guess it was my frustration. Apologies to all. I do know the riff here. Ok..once again from the top. It's potato.. video card is a tnt2 m64 (agp,32 mg) .made by pny tech. I got it from comp usa ( i hate to be forced into a position to go there)...anyways. I'm using an amd 750. Now..presently I'm putting this on a drive with 98se (20 gig quantum drive) but if I can even get to a decent install at all I'd like to replace mandrake (which is on its own drive,same box).. w/potato (or woody).. Ok..so I've tried using a pci card permedia 2 (8 mg). I've tried a number of diff bios settings..video shadowing off/on. chip caches off/on. Slow down then speed up ram timing (ddr here). PNP off/on..irq's auto/manual. There is no virus thingy with this bios. Now, I'm using the advanced method here as I like to pick my own packaging. I'm fairly hip to the dependency needs (the installer makes it real easy, it seems..lol. I've tried installing w/gnome included,and w/out... tried it with that unix desktop package and w/out. Was thinking there would be a conflict there,but never any messages to that effect. I made sure the complete x window system was included, and to not over ride any conflicts. Now, I have a rage 128 (32 mg,agp ) card I can try if the list feels this may be a solution ? I've also heard good things about the matrox products, and their support of linux? Ok..so I seem to be cool until I try to startx. I can cruise via midnight commander,visit linuxconf + a few other tasks I'm sure,just nothing that uses an x interface. Alright, I'm off to work some more on it and I'll check in later,hopefully with some good results. I'm very sorry for the novel here..I've been trying to work this out on my own for almost a month now..lol !! Thank you all..very very much. Lee .
