I have made a disk set from the Woody tree in order to install on an old IBM Aptiva 486DX2. I manage to load the rescue/root/driver disks just fine. Next I install my network module without problem and I continue to the network installation for the base system. This starts off allright, but ends with an error:
Failure trying to run: mount -t proc proc /proc and after that: debootstrap exited with an error Also, I am unable to write the bootstrap to the disk. I do not know what goes on here. I have tried to partition a 10MB /boot partition, but that does not help. Any pointers much appreciated! -- Erik van der Meulen <[EMAIL PROTECTED]>
