On Mon, Jun 11, 2001 at 12:45:03AM +0200, Mythiq wrote:
> hello everyone,
>
> I have compiled a new kernel for an 486 which was going to be a filtering
> firewall. Not for a while I'm afraid, because it won't boot up anymore. (btw:
> I started with a clean freshly installed system with debian 2.2.18pre21)
> Lilo works fine; it boots the kernel;
> after the kernel has started booting, there is a step where the ext2 fs root
> is mounted read-only (as usual);
> the next step is my problem: "kernel-panic, no init found. try to pass init=
> to the kernel." and there it halts.
>
> No problem I thought, reboot, hold shift at startup and inform lilo to pass
> init=/sbin/init to the kernel (which is a stupid thing to do since that is
> the default, this part ought to go by itself!) right: that did'nt work.
>
>
> Here's my big question: when I boot from a CD Linux-image, does my system
> still use the init in /dev/hda2/sbin/ ? (I think so since there's no init on
> the CD)
> Why then can my new kernel not use this init but more important: why can't my
> old kernel too! (the one after first installation residing on my HDD which is
> now named vmlinuz.old)
>
> Would be nice if anyone can help. baking a kernel on this machine takes about
> half a day...
Did you change your /etc/lilo.conf to reflect the new kernel changes?
Did you run /sbin/lilo after installing the new kernel?
If not that could be why you can't access your kernels.
At the boot prompt try
linux init=/bin/sh
or
linux single
That may get you in so you can fix your problem.
hth,
kent
--
From seeing and seeing the seeing has become so exhausted
First line of "The Panther" - R. M. Rilke
