What a bear this installation is! ´Kernel patches. Lots of new apps all of which seem to be in beta...
So my machine boots, sees the USB device but doesn't load the correct driver. I wonder why? Please take a look and let me know if dmesg is any help. Linux version 2.4.4 ([EMAIL PROTECTED]) (gcc version 2.95.4 20010506 (Debian prerelease)) #5 Fri May 25 12:03:43 BST 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 0000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) On node 0 totalpages: 32768 zone(0): 4096 pages. zone(1): 28672 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=Linux ro root=301 BOOT_FILE=/vmlinuz Initializing CPU#0 Detected 200.459 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 399.76 BogoMIPS Memory: 126236k/131072k available (1311k kernel code, 4448k reserved, 517k data, 204k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) CPU: Before vendor init, caps: 008001bf 00000000 00000000, vendor = 0 Intel Pentium with F0 0F bug - workaround enabled. CPU: After vendor init, caps: 008001bf 00000000 00000000 00000000 CPU: After generic, caps: 008001bf 00000000 00000000 00000000 CPU: Common caps: 008001bf 00000000 00000000 00000000 CPU: Intel Pentium MMX stepping 03 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED]) mtrr: detected mtrr type: none PCI: PCI BIOS revision 2.10 entry at 0xfb070, last bus=0 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Using IRQ router default [1106/0585] at 00:00.0 Activating ISA DMA hang workarounds. isapnp: Scanning for PnP cards... isapnp: Card 'Plug & Play Ethernet Card' isapnp: 1 Plug & Play card detected total Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Starting kswapd v1.8 parport0: PC-style at 0x378 [PCSPP(,...)] pty: 256 Unix98 ptys configured block: queued sectors max/low 83826kB/27942kB, 256 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later hda: QUANTUM FIREBALL SE8.4A, ATA DISK drive hdd: CDM-T531 Ver 1.041, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 16514064 sectors (8455 MB) w/80KiB Cache, CHS=1027/255/63 hdd: ATAPI 18X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 hda3 < hda5 > hda4 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 loop: loaded (max 8 devices) Serial driver version 5.05a (2001-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Linux Tulip driver version 0.9.14e (April 20, 2001) tulip0: 21041 Media table, default media 0800 (Autosense). tulip0: 21041 media #0, 10baseT. tulip0: 21041 media #4, 10baseT-FDX. tulip0: 21041 media #1, 10base2. eth0: Digital DC21041 Tulip rev 33 at 0x6200, 21041 mode, 00:80:C8:E4:36:49, IRQ 10. PPP generic driver version 2.4.1 PPP Deflate Compression module registered PPP BSD Compression module registered Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 96M agpgart: no supported devices found. [drm] Initialized tdfx 1.0.0 20000928 on minor 63 [drm:radeon_init] *ERROR* Cannot initialize agpgart module. SCSI subsystem driver Revision: 1.00 request_module[scsi_hostadapter]: Root fs not mounted Linux PCMCIA Card Services 3.1.22 options: [pci] [cardbus] usb.c: registered new driver usbdevfs usb.c: registered new driver hub NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. ds: no socket drivers loaded! VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 204k freed Adding Swap: 48188k swap-space (priority -1) Adding Swap: 72256k swap-space (priority -2) uhci.c: USB UHCI at I/O 0x6100, IRQ 11 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected uhci.c: USB UHCI at I/O 0x6300, IRQ 9 usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected hub.c: USB new device connect on bus2/1, assigned device number 2 usb.c: USB device 2 (vend/prod 0x6b9/0x4061) is not claimed by any active driver. usb.c: USB disconnect on device 2
