"Michael Janssen (CS/MATH stud.)" wrote: > In Franck Routier's email, 10-05-2001: > > Hello, > > > > I want to set up the route to a new box on my LAN. > > If the route is not set, the connexion is refused (I think this is an otion > > in the kernel networking configuration) > > > > Where should I put this route ? > > > > From the docs I have found it should go in /etc/network/interfaces, but I > > can't figure out what the syntax is... > > > > thanks, > > > > Franck > > taking a quick glance at interfaces(5), the most obvious thing for you > to do would be to add a 'up' command that gets executed. Then after > the interface comes up you could have a short script that just calls > `route` to set the correct route. If it's a dynamic IP and route this > might be a little tricky though. There are other similar methods for > 'down' to remove the routes.. > > -- > Michael Janssen - Jamuraa - [EMAIL PROTECTED] - [EMAIL PROTECTED] > GPG Fingerprint: 87F1 92C4 44AA 4105 B1C4 EDEC D995 9620 C00E 9159 > > ------------------------------------------------------------------------ > Part 1.2Type: application/pgp-signature
I'm interrested in the same thing, only I want to be able to edit my routing table upon startup to define the mss and window of my LAN and external gateway. Is there some sort of text stream I can run through to accomplish this? Stef
