On Mon, Mar 19, 2001 at 01:26:31AM -0800, David Carlile wrote: | Thanks for the quick reply. | | I tried modconf and selected rtl8193. I didn't include any parameters. I got | an error message: "Device or resource busy. Hint: this error can be caused | by incorrect module parameters, including invalid IO or irq parameters." | | Any ideas?
I think that browsing /proc/pci can give some information, but I haven't tried that yet. Have you used the card in windows? What does it report as the IRQ and IO addresses? | BTW, I checked the card and the link light is on, which kind of suprises me | because I didn't think I had a driver loaded... Is it possible a driver was I would expect the link light to be on if you have the card plugged into the service (or cable modem) because a link exists. If you unplug the card from the network the link light will go off. This is hardware independent of the software drivers. It is a convenient way to get information about which part of the card isn't working. My card (LinkSys) has link, 100, duplex, and tx lights to indicate if a link (network) exists, the network is 100 Mbps, the network is full duplex, the card is transfering data right not. -D
