>
> > Perhaps the idecd is installed into the kernel and is not a module.
> > You can check your kernel configuration in /boot/version/config.
> > That will tell what is configured as a module(=m) and what is
> > compiled directly into the kernel(=y).So check for the following:
> >
> > CONFIG_BLK_DEV_IDECD
> > CONFIG_SCSI
> > CONFIG_BLK_DEV_SR
> ______________
>
> This is from /boot/config-2.2.17:
>
> # CONFIG_BLK_DEV_HD_IDE is not set
> CONFIG_BLK_DEV_IDEDISK=y
> CONFIG_BLK_DEV_IDECD=y
> CONFIG_BLK_DEV_IDETAPE=m
> CONFIG_BLK_DEV_IDEFLOPPY=m
>
> These I couldn't find:
>
>
> > CONFIG_SCSI
> > CONFIG_BLK_DEV_SR
> ___________
> After changing 'aliases' and changing lilo and running 'update-modules'
> and running 'lilo'...
>
> It still doesn't work. When trying to install xcdroast it still
> complaining: 'no generic scsi support'...
>
> _________
>
> Could I just change in the
>
> /boot/config-2.2.17
>
> the line:
> ________
>
> CONFIG_BLK_DEV_IDECD=y
> into
> CONFIG_BLK_DEV_IDECD=m
> ________
>
> and remove that 'append line in lilo'?
Well since idecd is not a module, you need the append line.
The only way to change idecd to a module is to compile a new kernel.
But your kernel must also set CONFIG_SCSI and CONFIG_BLK_DEV_SR.
Now i assume you have CONFIG_CHR_DEV_SG and CONFIG_BLK_DEV_IDESCSI set.
If any of these are not set in your current kernel configuration
you will have to compile a new kernel and set them as modules.
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
