Thanks for you msg. What i'd like to would be to use hardware raid, i'm used to Compaq (HPAQ) servers whith smart array controller i thought i would get the same kind of functionality (limited to raid 0 and 1) on this ide controller.
I guess i'll toss out this controller and use the onboard ide controller (1 disk on each channel as i have a SCSI CD-Rom). Maybe i keep the controller just to try with a newer kernel. Guess Debian is out of hardware manufacturers linux distro list. I understand the difficulty to make a "for Linux" driver, and hope that LSB get's more attention in order to easy this Linux difficulties which M$ doesn't have. >-- >Got Backup? OOoops,...nnoope.. Thanks again Pedro Ruivo -----Mensagem original----- De: Nicos Gollan [mailto:[EMAIL PROTECTED]] Enviada: sexta-feira, 14 de Fevereiro de 2003 17:53 Para: [EMAIL PROTECTED] Assunto: Re: Hardware IDE ATA Raid 1 support in Linux Debian - Linux disapointment > Can someone tell me if it's possible, and how, to build a fault > tolerant (RAID1) system with this IDE controller. Has anyone got it to work > under Debian ? You could always use the controller as simple IDE controller using standard kernel drivers and build software RAID. For RAID 0 and 1 this usually produces a very minimal performance hit. You have to jump through some loops in order to make it bootable though. For information about that, here's a page that helped me set up a simple RAID1: http://unthought.net/Software-RAID.HOWTO/Software-RAID.HOWTO.html There are native Highpoint RAID drivers in kernel 2.4.20 (IDE, ATA and ATAPI Block devices -> Support for IDE Raid controllers), but I don't know how well those work. > I have to say one other thing, wich is the disappointmento with > linux in this concern, shouldn't there be "a Linux Driver" ? > I find drivers for Red Hat, Suse, Turbo, ... Linux but not for > Debian and specially not a "for Linux" Driver. Building drivers for specific distributions is usually easier that producing closed source "Linux drivers". When you write driver for, let's say RedHat 8.1, you know what kernel is installed and where to put config stuff. That's a lot more difficult with Linux in general since it's an uncontrolled battlefield. The LSB was supposed to make this easier, but... well... no. If you want a well-designed system, use *BSD. -- Got Backup? -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
BEGIN:VCARD VERSION:2.1 N:Ruivo;Pedro FN:Pedro Ruivo (TRQV-DSI) ORG:Tranquilidade Vida EMAIL;PREF;INTERNET:[EMAIL PROTECTED] REV:20020527T164102Z END:VCARD
