Hello, I have a Tekram Ultra 2 SCSI card (DC390u2b eq DC390u2w) with an IBM Ultra 2 SCSI(LVD) Hard disk installed on the Debian 2.2.
After successfully installed the Debian, I found a SCSI problem. Debian cannot run the SCSI(LVD) to 40MB full speed. (This system was installed Mandrake before and the SCSI Card was able to ran at 40Mb/s full speed by using NCR53cxx) Now, Debian is running it with the sym53c8xx on 10MB/s only. In Mandrake I don't need to install driver manually, it use ncr53cxx on 40MB/s automaticlly. Is there anyway I could fix this problem(such as modify a file) without install a offical Terkram SCSI driver? Here is the dmesg: scsi: <fdomain> Detection failed (no card) NCR53c486a: no avaliable ports found sym53c416.c: Version 1.0.0 sym53c8xx: at PCI bus 0, device 12, function 0 sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up) sym53c8xx: 53c895 detected sym53c895-0: rev=0x01, base=0xe1000000, io_port=0xb000, irq=11 sym53c895-0: ID7, Fast-40, Parity Checking sym53c895-0: on-chip RAM at 0xe000000 sym53c895-0: restart (scsi reset). sym53c895-0: Downloading SCSI SCRIPTS. sym53c8xx: at PCI bus 0, device 12, function 0, sym53c8xx: IO region 0xb000 to 0xb07f is in use Failed initialization of WD-7000 SCSI card! IBM MCA SCSI: No Microchannel-bus support present -> Aborting. megaraid: v107 (December 22, 1999) aec671x_detect: 3w-xxxx: tw_fincards(): No cards found. scsi0 : sym53c8xx -version 1.3g scsi : 1 host. Vendor: IBM Model: DENS-309170W Rev: SAH0 Tuye: Direct-Access ANSI SCSI revision: 03 Detected scsi disk sda at scsi0, channel 0, id6, lun0 sym53c895-0<6.*>: FAST-5 WIDE SCSI 10.0MB/s (200 ns, offset 31) Merry Christmas! Jacko p.s. This is the first time I use mailing list, if I posted to the incorrect mailling list, please forgive me and tell me where should I post to . Thank you. __________________________________________________ Do You Yahoo!? Yahoo! Shopping - Thousands of Stores. Millions of Products. http://shopping.yahoo.com/
