I am trying to hook a scanner up to my NCR 3350 using the built in SCSI
controller but the machine is crashing when I try to use it. I tried
searching with Google and Deja but couldn't find anything.
The machine is:
NCR 3350 (486dx2 upgraded to AMD586, 16MB RAM, MCA bus)
Debian Potato 2.2r1/DRDOS 7.02 (Linux loaded by Loadlin)
Built in NCR53C9x SCSI controller with:
2 Harddrives, and CDROM internal
HP ScanJet IIp scanner
No ID conflicts, no other SCSI problems.
When I run find-scanner I get the message "NMI generated from unknown
source!" and the SCSI bus locks up (LED on solid). Does anyone
know what causes this?
Here is the SCSI info from dmesg:
SCSI ID 7 Clock 25 MHz CCF=0 Time-Out 167 NCR53C9x(esp236) detected
Adapter found in slot 5: io port 0x240 irq 5 dma channel 3
scsi0 : NCR 53c9x SCSI
scsi : 1 host.
Vendor: SEAGATE Model: ST31230N Rev: HP04
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
Vendor: CONNER Model: CP30540 545MB3.5 Rev: B0C2
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 2, lun 0
Vendor: HP Model: C1790A Rev: 3226
Type: Processor ANSI SCSI revision: 02
Vendor: TOSHIBA Model: CD-ROM XM-3401TA Rev: 2873
Type: CD-ROM ANSI SCSI revision: 02
scsi : detected 2 SCSI disks total.
esp0: target 1 [period 200ns offset 15 5.00MHz synchronous SCSI]
SCSI device sda: hdwr sector= 512 bytes. Sectors= 2051460 [1001 MB]
[1.0 GB]
esp0: target 2 [period 200ns offset 15 5.00MHz synchronous SCSI]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 1045242 [510 MB] [0.5
GB]
eth0: SMC Ethercard PLUS Elite/A UTP/AUI (WD8013WP/A) found in slot 4
eth0: Parameters: 0x800, 00 00 C0 DB B9 09, IRQ 10 memory
0xc0000-0xc3fff.
Partition check:
sda: sda1 sda2
sdb: sdb1
--
Shawn D'Alimonte [EMAIL PROTECTED]
