what does this error message mean?
# sniffit -F dave -i
Forcing device to dave (user requested)...
Make sure you have read the docs carefully.
unknown physical layer type 0x30a
here, dave is a tunnel device created via
# create new device
$IPCMD tunnel add $DEV \
local $OUTSIDE_HERE \
remote $OUTSIDE_THERE \
mode $MODE \
ttl $TTL
# set it up to talk between these two points (with network on far end)
ifconfig $DEV \
$INSIDE_HERE pointopoint $INSIDE_THERE \
netmask $MASK
and i can use it to tunnel windows file-share services,
so it's working just fine --
# ifconfig dave
dave Link encap:UNSPEC HWaddr
D0-21-5A-55-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:192.168.1.1 P-t-P:192.168.0.1
Mask:255.255.255.0
UP POINTOPOINT RUNNING NOARP MTU:1476 Metric:1
RX packets:4300 errors:0 dropped:0 overruns:0 frame:0
TX packets:4308 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:0
# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
208.33.90.0 0.0.0.0 255.255.255.0 U 0 0 0
eth1
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0
eth0
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0
dave
0.0.0.0 208.33.90.84 0.0.0.0 UG 0 0 0
eth1
but what's up with sniffit?
when i just
# sniffit -i
all i see are my existing login/ssh sessions, altho i
can still ping 192.168.0.2 (which is past the remote end
of the tunnel, which is 192.168.0.1; my end is 192.168.1.1).
unfortunately, when running 'sniffit -i' the only options are
to check certain ports and certain ip numbers, not specific
devices.
--
things are more like they used to be than they are now.
[EMAIL PROTECTED] *** http://www.dontUthink.com/
