Just realized that windows probably should be first on your hd and then use lilo as i described below.
> Read /usr/share/doc/lilo/Manual.txt.gz. and put a new line > in your lilo.conf immediately after the delay line: > lba32 > With this, lilo as of version 1:21.4.2 now supports booting > from above cylinder 1024 (~8 GB). > I have a 13GB hd and my lilo boots o/s any where on > my hd. > > On Wed, 11 Oct 2000 17:10:58 +0900, Jack Morgan said: > > > Sorry if this has been discussed before, > > > > I can't get lilo to boot a windows partition which is after the 1024 > cylinder. > > I beleive that now it is able to, but...not sure how? > > My lilo.conf is setup as follows: > > > > boot=/dev/hda > > root=/dev/hda5 > > install=/boot/boot.b > > map=/boot/map > > vga=normal > > delay=20 > > image=/vmlinuz > > label=Linux > > read-only > > other=/dev/hda3 > > table=/dev/hda > > label=Windows > > > > Thanks in Advance... > > -- > > Jack Morgan Debian GNU/Linux > > Email: [EMAIL PROTECTED] > > Web-site: www.mandinka.org > > > -- > gEEk||dOOd^Deb+ian&&XFce$everything goes<Pronto>(-_-
