On Thu, Aug 24, 2000 at 09:52:46PM -0700, Aaron Maxwell wrote: > one more: how do I specify the parameters for IO address and IRQ?
For a tulip? I don't think you do. It should put itself where it pleases. > yomama:~# insmod /lib/modules/2.2.17/net/tulip.o > /lib/modules/2.2.17/net/tulip.o: init_module: Device or resource busy > Hint: insmod errors can be caused by incorrect module parameters, > including invalid IO or IRQ parameters Try the old_tulip module... might have better luck with that. Also try using modprobe instead of insmod. modprobe will drag in module dependencies for you (and some network cards depend on 8390.o -- not sure if tulip does, though). -Dan -- "... the most serious problems in the Internet have been caused by unenvisaged mechanisms triggered by low-probability events; mere human malice would never have taken so devious a course!" - RFC 1122 section 1.2.2
pgpHV3qYTsuL7.pgp
Description: PGP signature
