Hi,
Thanks.
But I have done more changes in the getty configuration and now it
prints:
INIT: ID "S2" respawning too fast: disabled for 5 minutes
What is wrong this time?
Quoting Richard Kaszeta ([EMAIL PROTECTED]):
> Paulo Henrique Baptista de Oliveira writes ("Mgetty+Cyclades"):
> >I'm trying to use mgetty to control my Cyclades ports to use a¨56K modem as
> >dial in
> >
> >I used setserial so my serial on ttyC0 is set like that:
> >
> > ttyC0, Line 0, UART: Cirrus, Port: 0x0000, IRQ: 2
> > Baud_base: 115200, close_delay: 50, divisor: 0
> > closing_wait: infinte, closing_wait2: infinte
> > Flags: spd_vhi
> >
> >I put a line on inittab to load mget on ttyC0
> >
> > S3:23456: respawn:/sbin/mgetty -x3 ttyC0
> >
> >and on mgetty.config i set a line to the serial on ttyC0 like that
> >
> > port ttyC0
> > debug 3
> > speed 56600
>
> This should be 57600
>
> --
> Richard W Kaszeta PhD. Candidate and Sysadmin
> [EMAIL PROTECTED] University of MN, ME Dept
> http://www.menet.umn.edu/~kaszeta
--
Abraços, PH
Paulo Henrique Baptista de Oliveira -- [EMAIL PROTECTED]
Information Technology Consultant
Linux Solutions -- http://www.linuxsolutions.com.br
Av. Presidente Vargas, 509/4o andar - 852-4564 - Rio de Janeiro - RJ
Brazil
