I just purchased a pci-modem from Actiontec that uses a Lucent chip and
on the box it says it is compatible with Linux. I have to create a
ttyS4 (com 5)
I have done a /dev/MAKEDEV ttyS4 and this appears to create the file.
I then try to setserial /dev/ttyS4 uart 16550A port 0xd800 irq 5
but I get "device ttyS4 not found"?
How do I create ttyS4? Here is the info when I cat /proc/pci
Bus 0, device 9, function 0:
Communication controller: Lucent (ex-AT&T) Microelectronics
Unknown device (rev 0).
Vendor id=11c1. Device id=480.
Medium devsel. Fast back-to-back capable. IRQ 5. Master Capable.
No bursts. Min Gnt=252.Max Lat=14.
Non-prefetchable 32 bit memory at 0xef001000 [0xef001000].
I/O at 0xd800 [0xd801].
I/O at 0xdc00 [0xdc01].
I/O at 0xe000 [0xe001].
