Thanks for the reply, but it's still not working.
My /etc/ppp/peers/provider:
# This file was generated by pppconfig. You can edit the following
lines
# but please do not delete lines or the change the comments or you will
# confuse pppconfig.
noauth #pppconfig_noauth
connect "/usr/sbin/chat -v -f /etc/chatscripts/provider"
#pppconfig_connect
debug #pppconfig_debug
/dev/ttyS0 #pppconfig_dev
115200 #pppconfig_speed
defaultroute #pppconfig_route
noipdefault #pppconfig_ipdefault
user ELN/werner1 #pppconfig_user
# End of pppconfig controlled lines. You can add lines below here
without
# confusing pppconfig.
demand idle 600 holdoff 5
10.0.0.1:38.12.23.34
ipcp-accept-local
ipcp-accept-remote
After doing those changes the modem still does not dial.
xanadu:~# pon
xanadu:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:20:AF:41:5A:F9
inet addr:192.168.1.100 Bcast:192.168.1.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:26 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x300
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:377 errors:0 dropped:0 overruns:0 frame:0
TX packets:377 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
ppp0 Link encap:Point-to-Point Protocol
inet addr:10.0.0.1 P-t-P:38.12.23.34 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
xanadu:~# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
38.12.23.34 * 255.255.255.255 UH 0 0 0
ppp0
localnet * 255.255.255.0 U 0 0 0
eth0
default 38.12.23.34 0.0.0.0 UG 0 0 0
ppp0
xanadu:~# ping 38.1.1.1
PING 38.1.1.1 (38.1.1.1): 56 data bytes
ping: sendto: Operation not permitted
ping: wrote 38.1.1.1 64 chars, ret=-1
ping: sendto: Operation not permitted
ping: wrote 38.1.1.1 64 chars, ret=-1
ping: sendto: Operation not permitted
ping: wrote 38.1.1.1 64 chars, ret=-1
--- 38.1.1.1 ping statistics ---
3 packets transmitted, 0 packets received, 100% packet loss
xanadu:~#
However, it seems this is all moot as I've come up against a seperate
problem. Last night I left that box (xanadu) up all night. When I came
home from class this afternoon the machine had completely locked up.
The screen had blanked, telnet no longer responded, neither did ftp, nor
did ping. Nothing responded at all. As far as any other machine on the
LAN was concerned xanadu was gone. So I had to reboot using the reset
button on the case. I'm suspecting hardware problems. Joy.
--
Mike Werner KA8YSD | "Where do you want to go today?"
ICQ# 12934898 | "As far from Redmond as possible!"
'91 GS500E |
Morgantown WV | Only dead fish go with the flow.
