"Jonathan D. Proulx" wrote:
>
> Hi,
>
> /dev/ttyS3 is my modem. The hardware is jumpered for IRQ 5.
> I added the following line to setserial:
>
> ${SETSERIAL} -b /dev/ttyS3 irq 5 port 0x2E8 skip_test autoconfig ${STD_FLAGS}
>
> The problem is the irq frequently reverts to 3. This happens after
> closing my dial up connection (although not always). Also, starting X
> almost always closes my dialup connection (I don't know if this is
> related)
I had the IRQ reversion problem when I was had kernel serial
support compiled as a module. Apparently, when the module gets
unloaded and then reloaded, anything that was in
/etc/rc.boot/0setserial no longer has any effect. I fixed this
first by putting 'serial' in my /etc/modules, but now I just
compile serial support directly into the kernel.
Don't know about the X problem.
- Kris
