Hi, I just upgraded my mother board from a K6-2/233 to a K6-3/400. same memory, same periferals. I have been booting from a ls120 with a rescue disk, One of the reasons to upgrade the mother board was to get a working floppy controller. Now using the LS-120, the floppy or from cd trying to boot a rescue floppy or a boot floppy, the boot process hangs when trying to setup the SCSI controller. The controller is an Adaptec AHA-2940. message all look correct/normal until it gets to Downloading sequencer code... 406 instructions downloaded then the boot just stops. I've noticed this before when I had a "bad" rescue disk. Good boots usually downloaded 407 or 413 instructuctions. To work arround this I pulled the scsi controller. Now it boots OK but I'd like to have my Jaz drive.
The second problem is that the mouse does not work. The setup looks fine using XF86Setup but the mouse does not work in X. When I boot in console mode, gpm dameon is running but I don't the mouse does not work there either. Both of these devices work fine in NT. My linux system is 2.0.34 or a Hamm system, 2 hard drives Any ideas?? Thanks, Jim ********************************************************************** Jim Harsh 505-665-0485 DX-3 MSP940 Los Alamos National Laboratory Los Alamos, NM 87545 **********************************************************************
