Phil Newcombe wrote: > > All I did was download the files recommended in the 'Getting Started' guide > for hard > disk installation, ran 'install' and followed the instructions. > > Phil N > > Kent West wrote: > > > At 07:16 PM 3/14/1999 -0400, Maria Helena Albornoz Vasquez wrote: > > > > > > Hello, > > > > > > I'm a Linux beginner and I want to install Linux in my computer but I > > > experienced some problem. > > > > > > I have a Pentium 133 Mhz, 32 Mb RAM with a 1.6Gb hard disk with Win95 > > > installed. > > > The hard disk is yet partitionned (with the windows95 Fdisk) as follow : > > > Primary partition 600 Mb contains Win95 and other software > > > 1st logical partition 600 Mb contains users files > > > 2nd logical partition 346 Mb where I want to install Linux > > > I can't backup my disk so I don't want to make a new partition, neither > > > make > > > a swap partition (Afraid to loose data). > > > > > > So I try to install Linux without the swap partition. > > > When I want to install the linux Kernel, the system ask me for the > > > resc1440.bin file. But when I put the rescue floppy or when I indicate the > > > location of this file on the first partition /dev/hda1, then installation > > > software answer "The attemp to open the resc1440.bin file failed" o > > > something > > > like this. > > > What's happening ? I redownload this file in the case of being corrupted > > > and > > > I make new rescue disks but the problem still there. > > > > > > I have downloaded from the Debian FTP the image files resc1440.bin, > > > drv1440.bin and the base2_1.tgz file in order to install from the DOS > > > partition. > > > > > > Another thing : how can I print the hardware list that appears at the > > > beginning of the installation software ? > > > > > > Your help will be welcome. > > > > > > Alex > > > > > > > Floppies are notorious for causing problems on an install. You did good to > > try > > downloading the file again, but what I bet you need to do is to try a > > different > > floppy. Use a good-quality floppy. I've known of at least one case where the > > person installing Linux had to try four different floppies before getting > > one > > to work properly, even though they all seemed to be good disks. > > > > Concerning your question about the hardware list at the beginning of the > > installation software, I'm not sure what you're talking about. > > > > Hope this helps. > > > > -- > > Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null > > -- > 'The Newcombe House' http://users.uniserve.ca/~newcombe/ > > --- time will tell ---
Ah, my bad; I didn't read closely enough. Reading back through, I see you didn't want to create a swap partition. I believe you either need a swap partition or a swap file. I've never used a swap file, so maybe someone on the list can help there. However, what I'd recommend is that during the Linux install, delete the 346 MB partition (assuming it was created with DOS's fdisk), then recreate a Linux partition of, say, 614 MB, and create a Linux swap partition of 32 MB. I think that may get you past this bump in the road. Kent West [EMAIL PROTECTED]
