My initial install of the kernel 2.2.0 was not too good. I have to admit, I do not keep up with the development kernels, only the stable ones... so I felt very newbie-ish upon the problems.
IPMasq... It is simply not setup the same. ipfwadm does not work anymore and I needed to use ipchains. also adding the 'echo "1" > /proc/sys/net/ipv4/ip_forward' was something new as well. Once this was in place diald and ppp was working (PPP built in the kernel and SLIP as a module). LP, however, I cannot figure out. I have parport (tried in the kernel and as module), parport_pc.o and lp.o all built. I cannot get it to detect my printer? I know it is going to use /dev/lp0 instead of /dev/lp1, but the kernel reports that no devices have been found? very odd. All I have to do is reboot to my previous 2.0.36 kernel and it detects the printer fine. Any thoughts? --Jay
