Hi!
I've just installed two ethernet cards on my system and now I have
problems routing some stuff between the two networks.
Here's my setup:
# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:124124 errors:0 dropped:0 overruns:0 frame:0
TX packets:124124 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
eth0 Link encap:Ethernet HWaddr 00:A0:24:52:32:41
inet addr:147.83.61.17 Bcast:147.83.61.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4563431 errors:0 dropped:0 overruns:0 frame:0
TX packets:1473089 errors:0 dropped:0 overruns:0 carrier:50
Collisions:22947
Interrupt:10 Base address:0x300
eth1 Link encap:Ethernet HWaddr 00:20:18:81:D3:41
inet addr:147.83.61.17 Bcast:147.83.61.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:446391 errors:0 dropped:0 overruns:0 frame:0
TX packets:891034 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
Interrupt:12 Base address:0x6500
# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
147.83.61.164 * 255.255.255.255 UH 0 0 7 eth1
localnet * 255.255.255.0 U 0 0 1294 eth0
127.0.0.0 * 255.0.0.0 U 0 0 287 lo
default phc3.upc.es 0.0.0.0 UG 1 0 4847 eth0
Ok. Now my problems.
The 147.83.61.164 (the only machine in the other network) is able
to access 147.83.61.17, but nothing apart from that. I've compiled the
kernel with forwarding:
# grep ip_forward /proc/ksyms
00142b28 ip_forward_Re64d1b3f
001d3768 sysctl_ip_forward_Ra7d20d83
Also, the people on eth0 side can not access eth1 side (just the
.164) machine.
The .164 machine is a w95 machine configured to used .17 as the
gateway.
Any help would be greatly apreciated in getting both networks to
talk to each other!
TIA!
Salutacions, Pere ---- __o Ultima Ratio Regum
2:343/108.91 ----- _`\<;_ mailto:[EMAIL PROTECTED]
PGP key available --- (_)/ (_) http://casal.upc.es/~pere/
