Steve M. Robbins wrote:
This is just a guess, but I believe the initrd.img file is specific for each kernel...i.e. if you look at the "/initrd.img" file it is just a symlink to /boot/initrd-[some specific kernel image file]. Since BOTH of your kernels need a different but "specific" initrd.img file you need to place this command in each kernel image stanza and edit to make sure it is pointing to the specific initrd.img for that kernel. Here is what I would do: (there are probably other solutions)-SNIP- < I'm at a loss now: where should I be looking next?Thanks, -Steve ----------------- lilo.conf ------------------- boot=/dev/hda root=/dev/hda3 install=menu map=/boot/map vga=normal # Needed for debian kernel packages initrd = /initrd.img # Show me the LILO prompt ... prompt # ... but wait no more than this (tenths of second) timeout = 200 image=/vmlinuz label=Linux read-only other=/dev/hda1 label=Win table=/dev/hda image=/vmlinuz.old label=OldLinux read-only optional ---------------------------------------------------
> boot=/dev/hda
> root=/dev/hda3
> install=menu
> map=/boot/map
> vga=normal
>
> # Needed for debian kernel packages
> # initrd = /initrd.img <----comment out this line in the "general" section so it doesn't apply to all kernel "stanzas".
>
>
> # Show me the LILO prompt ...
> prompt
>
> # ... but wait no more than this (tenths of second)
> timeout = 200
>
>
> image=/vmlinuz
> label=Linux
> read-only
initrd=initrd.img <--add this and symlink it to /boot/initrd.img-2.4.20
>
>
> other=/dev/hda1
> label=Win
> table=/dev/hda
>
>
> image=/vmlinuz.old
> label=OldLinux
> read-only
initrd=initrd.img-old <add this and symlink it to /boot/initrd.img-2.4.19
> optional
>
You may have to clean up the file names to match what it on your system, but this should give you the idea. Make sure to run "lilo" after the edits.
HTH.
Cheers,
-Don Spoon-
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
