Hi,
To use kernel`s raid0 support for swap partitions, I added
these two lines to /etc/fstab
/dev/hdc2 none swap sw 0 0
/dev/hda1 none swap sw 0 0
But boot messages says these partitions have different priorities
(-1 and -2).
Any ideas? Thanks in advance.
>From mdutils docs:
2 Swapping over RAID
The kernel has native support for distributing swap space over
several disks. Just add all swap partitions to /etc/fstab and use
'swapon -a' to activate all of them. The kernel uses striping
(RAID-0) for them. Here's a sample setup:
/dev/sda3 none swap sw
/dev/sdb3 none swap sw
>From swap(2) man:
Swap pages are allocated from areas in priority order,
highest priority first. For areas with different priori-
ties, a higher-priority area is exhausted before using a
lower-priority area. If two or more areas have the same
priority, and it is the highest priority available, pages
are allocated on a round-robin basis between them.
--
Deniz Dogan
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
