Hey again,
Thanks for all the fast replies ..
Yes .. ne was in /etc/modules .. and so it tried to load it on
top of the kernel one ..
Shouldnt make modules_install write over this file or something .. or
be made too ?? with the up to date modules to run.
Anyways .. the ether card doesnt look like its the problem ..
With only the following lines in /etc/init.d/netork :
#! /bin/sh
ifconfig lo 127.0.0.1
route add -net 127.0.0.0
ie. only loopback .. still get operation not permitted ..
Had to check my sanity .. and make sure networking was compiled in
the Kernel with everything .. it was .. saved config .. then recompiled
installed etc, just in case .. still no luck.
[EMAIL PROTECTED]:~# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
[EMAIL PROTECTED]:~# ping 127.0.0.1
PING 127.0.0.1 (127.0.0.1): 56 data bytes
ping: sendto: Operation not permitted
ping: wrote 127.0.0.1 64 chars, ret=-1
ping: sendto: Operation not permitted
ping: wrote 127.0.0.1 64 chars, ret=-1
--- 127.0.0.1 ping statistics ---
2 packets transmitted, 0 packets received, 100% packet loss
[EMAIL PROTECTED]:~# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:0 error:0 dropped:0 over:0 frame:0
TX packets:0 error:0 dropped:0 over:0 carrier:0 coll:0
regards,
--
NiNJA
[EMAIL PROTECTED]
-= GiGz.net - The netwerk that goes "d00f" =-
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
