(The subject line is a bit misleading, don't you think?) Hans> loading device 'eth0'... Hans> eth0: 3c509 at 0x300 tag 1, 10baseT port, address 00 a0 24 e7 06 66, IRQ 3 Hans> 3c509.c:1.07 6/15/95 [EMAIL PROTECTED]
Hans> But when I boot the machine it says: Network is unreachable Is your network actually connected through the 10baseT port on the card? With 3c509 cards I have often had to start up a 3com config program and set them "by hand" to BNC instead of "auto-detect" (and I switch off Plug and Play while I am at it). I have always used the DOS 3com509 config program that comes with the cards (probably available from the 3com web site too), but I have a vague memory of somebody mentioning a Linux tool to do the job. Hope this helps. -- Gilbert Laycock email: [EMAIL PROTECTED] Maths and Computer Science, http://www.mcs.le.ac.uk/~glaycock Leicester University phone: (+44) 116 252 3902 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
