>>>>> "Jens" == Jens B Jorgensen <[EMAIL PROTECTED]> writes:
Jens> I use a Zyxel OMNI TA 128U (almost the exact same beast) with a single 64K Jens> channel. It has no problems. My server machine is a P90 overclocked to 100 with Jens> 40MB of memory. Perhaps you're getting buffer overruns on your serial port. What Jens> baud rate are you running your serial port at? I am using 115200 in my pppd options file, and use setserial with the spd_vhi flag on the device. And I am only using a single channel. I have made some progress though. I was using an extra serial port I had installed. Though there should be no IRQ conflicts, removing that board and using the builtin one (COM2) made the whole thing run much better. However, I am still not able to get the ISDN line up when X11 is running (due to massive ppp frame fcs problems). I am suspecting that I am experiencing IRQ priority problems (could be that X increased the latency of some higher priority IRQ), but having spent a couple of hours with my nose in Serial-programming HOWTO did not help much. Irqtune did not seem to make any difference to that problem. Is my PC just too slow? ---------------------------+-------------------------------------------------- Christian Lynbech | Telebit Communications A/S Fax: +45 8628 8186 | Fabrik 11, DK-8260 Viby J Phone: +45 8628 8177 + 28 | email: [EMAIL PROTECTED] --- URL: http://www.telebit.dk ---------------------------+-------------------------------------------------- Hit the philistines three times over the head with the Elisp reference manual. - [EMAIL PROTECTED] (Michael A. Petonic) -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
