hallo linux specialists, so far I'm not a specialist myself, but I just want to install the system, and it does not startup.
It is a digital DECpc 466d2 MTE (EISA) with 16MB RAM, Adaptec 2740 SCSI controller, 2GB Quantum Fireball Tempest (SCSI), Toshiba SCSI-CDROM, Wangtek SCSI Tape drive, Ethernet adapter (Intel EtherExpress) and ISDN adapter (Teles S0-16.3 NO Plug&Play) An IDE harddisk and it's controller are disabled in the BIOS, the SCSI harddisk is partitioned with 2 FAT and 2 NTFS partitiones - I want to remove them all during installation after one successful linux startup to run linux only on this station. The boot prompt appears all right, then loading linux hangs up with the following last lines at screen: ... aic7xxx: Resetting the SCSI bus...done. qlogicisp : PCI bios not present eata_dma: No BIOS32 extensions present. This driver release still depends on it. o Skipping scan for PCI HBAs. aic7xxx: (aic7xxx_isr) Encountered spurious interrupt. scsi0: BRKADRINT error (0x1): Illegal Host Access Kernel panic: scsi0: BRKADRINT, error 0x1, seqaddr 0x0. That's it. Only valid actions then are Power Off or RESET. No change loading with linux aic7xxx=no_reset Any hints? Not to forget: A Happy New Year to all who have read till here. Gesine and Stephan -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED] .
