Yo-
I just installed a new 10/100 ethernet card which uses DEC's "tulip"
(21140) chipset. I have compiled in the support for the tulip and it
shows no errors during start-up but I am unable to access the network.
I am able to ping the loopback but when I try to ping another machine or
my router i get "eth0 enabled 100tx port". It appears as if it wants
100tx but this is the only host on my LAN with a 100tx card so I am really
running at 10mbps.
Is there a file or something else I need to edit to make sure it tries to
use 10mbps instead of 100? Is that the problem?
I am running 2.0.30 on a PPro 200 if that matters.
Thanks in advance!
-Ian
p.s. HELP!! I don't want to use Window's networking!
_____________________________________________________________________
.__. __ __
| | .__. .__. .__. .__. .__. \ \ / /
| | | | | \ | | | | | | \ \ / /
| | | | | |\ \ | | | | | | \ \/ /
| |__ | | | | \ \| | | |_| | / / \ \
|__|__.|__| |__| \____| |_______| /_/ \_\
* DEBIAN GNU/Linux *
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
[EMAIL PROTECTED] .
Trouble? e-mail to [EMAIL PROTECTED] .
