I don't know why I keep trying to use modules, they never work right for me....
I trashed my 1.2.13 system on my home box and installed 2.0.2?. Dselect didn't work, so I did a manual job with dpkg. I installed the kernel source and compiled it fine. Did the make modules and make module_install and everything seemed to have gone on OK, but when I boot I get the error message "no dependancy information for XXX module". And, of course the modules don't install. I have to do a manual install to make things work. What is wrong? While I'm asking for help, setserial doesn't seem to work the way it used to and I can't figure out what to do. It used to be when I typed setserial it found all my serial ports and configured them fine. Now it can't seem to figure out that /dev/cua2 is connected to IRQ 2, not 4. Who dumbed down setserial? I tried the "autoconfigure" option, but it said that wasn't a valid option, Huh? I also tried another option, autosomethingelse, I don't remember what it was, but setserial didn't seem to do anything or if it did, it was silent. Anyway, I guess I can tell setserial to use IRQ 2, but since it used to figure it out, I sort of think it should still be able to do so. About dselect.... Ah never mind. I've been trying to use it for years and never have been able to figure it out. Oh, I've installed from an iConnect CD mastered on 3 October. Thanks, Jim. -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED]
