Hello, Thank you for the information. How current is the link below. I got this from my colleague.
http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/i386/rc3/sarge-i 386-netinst.iso I have a broadcom Ethernet adapter in the HP dx600 machine which is two weeks old. Will this software install everything, or can you forward me the link to new sarge software. Would I have to install the debian seven disks. >From Jatin Patel Technical Engineer -----Original Message----- From: Christian Mack [mailto:[EMAIL PROTECTED] Sent: 20 May 2005 13:23 To: Jatin Patel Cc: debian-user@lists.debian.org; debian-boot@lists.debian.org Subject: Re: boot problems Hi Jatin Patel Jatin Patel wrote: > hello, > > I have downloaded debian 3.05 and have burnt these to disks, they were > ISO images. I assume here you mean the full CD-set debian 3.0 r5 (= woody revision 5). This has definitely nothing to do with development of the new installer of sarge, so you should keep this thread on [EMAIL PROTECTED] only. > Unfortunately when i out disk 1 into the computer boots up this is the > message "attempting to boot from hard disk", "LI", "attemtempting to > boot from cd rom". > > Any help. > > Debian 3.04 installs from my collegues disk, was there any specific > way i should have burnt the disks? i was nero. > > Jatin Patel > Technical Engineer > As you can boot from another CD, your BIOS settings seem to be OK. Don't add this file to nero's explorer! You have to open the ISO image within nero in order to burn it. You can check this, by looking at the CD after burning. If you see one *.iso file on it, you've done it wrong :-P BTW: Sarge is going to be released shortly after end of May. If you are installing a newer machine (e.g. with SATA drives) this should be the route to go. Hope this helps a bit. Bye Christian
