Kent West <[EMAIL PROTECTED]> wrote:
> Marc Shapiro wrote:
>
> >The old card was an ISA NE2000 compatible card.
> >
> >The new card is a PCI Network Everywhere NC100U-WM.
<SNIP>
> >I tried to run 'modprobe tulip' but I get the
> >following error:
> >
> ># modprobe tulip
> >Note: /etc/modules.conf is more recent than
> >/lib/modules/2.2.17/modules.dep
> >/lib/modules/2.2.17/net/tulip.o: init_module:
> Device
> >or resource busy
> >Hint: insmod errors can be caused by incorrect
> module
> >parameters, including invalid IO or IRQ parameters
> >/lib/modules/2.2.17/net/tulip.o: insmod
> >/lib/modules/2.2.17/net/tulip.o failed
> >/lib/modules/2.2.17/net/tulip.o: insmod tulip
> failed
> >#
> >
> >
> What does "lspci -vv" report about the card?
Results here:
00:04.0 Ethernet controller: Linksys Network
Everywhere Fast Ethernet 10/100 model NC100 (rev 11)
Subsystem: Linksys: Unknown device 0570
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV-
VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr-
DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (16000ns min, 32000ns max), cache line
size 08
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at 2400
Region 1: Memory at 41100000 (32-bit,
non-prefetchable)
Capabilities: <available only to root>
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
