Dear Debian Users
I have been working with a network problem the last two days without any result. I am posting this here in the hope that perhaps someone else can understand what I can't seem to figure out.
I am having to network card in my machine eth0 and eth1. eth0 is used in my local network at home and it is not the issue.
eth1 is used to connect to my ISP. My ISP is using FWA technology.
In my /etc/network/interfaces I used to have this:
auto lo iface lo inet loopback
auto eth1 iface eth1 inet dhcp
auto eth0 iface eth0 inet static address 192.168.0.1 netmask 255.255.255.0
As you can see all very simple.
Normally my ISP would use public IP's but has now decided to move to intern IP. This means that my eth1 now gets something like 10.x.x.x instead of the public one.
Since I very much would like a public IP my ISP made me a PPPoE connection which I have tested on windows XP where it works perfektly.
On debian I ran apt-get install pppoe pppoeconf I then ran the pppoeconf
In the debian reference I read about using PPPoE and I then changed the /etc/network/interfaces to:
auto lo iface lo inet loopback
iface eth1 inet ppp provider dsl-provider
auto eth0 iface eth0 inet static address 192.168.0.1 netmask 255.255.255.0
When I use pon dsl-provider and then ifconfig I get:
eth0 Link encap:Ethernet HWaddr 00:50:04:41:5A:67
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:10945 errors:0 dropped:0 overruns:0 frame:0
TX packets:14005 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1169319 (1.1 MiB) TX bytes:4020685 (3.8 MiB)
Interrupt:10 Base address:0xa000eth1 Link encap:Ethernet HWaddr 00:60:97:A5:79:5F
inet addr:10.10.0.93 Bcast:10.31.1.255 Mask:255.255.254.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:47349 errors:0 dropped:0 overruns:0 frame:0
TX packets:697 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4585915 (4.3 MiB) TX bytes:45761 (44.6 KiB)
Interrupt:9 Base address:0x9800lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:430 errors:0 dropped:0 overruns:0 frame:0
TX packets:430 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:44762 (43.7 KiB) TX bytes:44762 (43.7 KiB)ppp0 Link encap:Point-to-Point Protocol
inet addr:80.110.21.5 P-t-P:10.254.0.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1484 Metric:1
RX packets:8 errors:1 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:649 (649.0 b) TX bytes:109 (109.0 b)All looks fine and ppp0 has got the right IP. If I run route I get:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.254.0.1 * 255.255.255.255 UH 0 0 0 ppp0
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
10.10.0.0 * 255.255.254.0 U 0 0 0 eth1
default 10.254.0.1 0.0.0.0 UG 0 0 0 ppp0
All looks fine. But when I ping I can't reach anything.
ping www.google.dk ping: unknown host www.google.dk
ping 212.242.40.3 PING 212.242.40.3 (212.242.40.3): 56 data bytes ping: sendto: Operation not permitted ping: wrote 212.242.40.3 64 chars, ret=-1 ping: sendto: Operation not permitted ping: wrote 212.242.40.3 64 chars, ret=-1
--- 212.242.40.3 ping statistics --- 2 packets transmitted, 0 packets received, 100% packet loss
What am I doing wrong?
The kernel is running with the necessary pppoe driver.
Thanks in advance
Regards, Kim
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
