Hello: I have finally broken down and installed CUPS, which seems to work pretty well for two printers, an HP PSC2175 and a Brother HL1440. However, I have run into a few rough spots. Besides driver issues for the HP, I have a problem that has happened often enough to start to bug me.
As mentioned in the subject line, it has happened a few times that at some point, even when the printer has been working, some small change in the parameters or some unknown factor will cause the printer to just stop accepting jobs, or else the system to stop passing them to the printer. On one instance, using Sane to scan from the HP PSC2175 and print to the HL1440, the scans went perfectly and printed ok on the Laser printer (giving me a copy function at a much cheaper cost). Then for one scan I decided to specify in the Sane dialog for two copies to be printed. It worked fine. Then the next time around, I specified one copy, but nothing happened. I repeated the command several times. Other print jobs could not print either. After rebooting, the printer cranked out pending jobs. In another instance, today, jobs sent to the HP printer didn't print. I rebooted, and the copies printed ok. I tried /etc/init.d/cupsys restart, but this didn't work. I had similar problems with lpd/lpr for perhaps years, which I have always had to solve with the /etc/init.d/lpd stop/start trickery. I have looked at the CUPS docs, but haven't figured this out. Is this problem familiar to anyone? Alan Davis [EMAIL PROTECTED] Kagman High School Saipan -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
