I am running a new installation of Sid and can't seem to get the modem up.
lspci -vv shows:
02:0a.0 Serial controller: 5610 56K FaxModem 56K FaxModem Model 5610 (rev 01)
(prog-if 02 [16550])
Subsystem: 5610 56K FaxModem USR 56k Internal Voice Modem (Model 2976)
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 22
Region 0: I/O ports at dfe0 [size=8]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI- D1- D2+ AuxCurrent=0mA
PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
There is a line from dmesg with the above port and irq:
ttyS14 at I/O 0xdfe0 (irq = 22) is a 16550A
However, there is no ttyS14 in /dev/. Do I need to make it somehow?
I also have Fedora running on this computer. It recognizes the modem fine.
/dev/modem -> /dev/ttyS4
I tried setserial as follows:
setserial /dev/ttyS4 uart 16550A port 0xdfe0 irq 22 autoconfig
ln -sf /dev/ttyS4 /dev/modem
I followed this with "pppd call provider". I don't believe it activated the
modem.
Any thoughts as to how I might proceed?
Gary Parker
Cayuse, OR
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
