My question is how to I get this set up early in the install process so I can proceed with install as normal?
Alternatively, how do I set up the card now that I have a very minimal install & then proceed with base-config?
Sorry, I'm a total newbie really, not inept, just needing instructions.
Thanks all, Rua HM.
>I'm a fellow newbie and had the same problem. After getting a lot of >> bad advice I finally had to install it from source. I forgot where I >> got it but the filename was bcm4400-2.0.5.something. > http://broadcom.com/drivers/downloaddrivers.php > voila, and GPL license too.
joost -- Rua Haszard Morris Software Engineer & Research Assistant MARCS Auditory Laboratories University of Western Sydney http://marcs.uws.edu.au
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
