-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
I've tying to configure xfree86 on a old PIII450, it running Sarge. It has a on-board graphics card, the output from lspci is
pcilib: Cannot open /sys/bus/pci/devices 0000:00:00.0 Host Bridge: Intel Corp. 82810 GMCh [Graphics Memory Controller Hub] (rev 03) 0000:00:01.0 VGA compatable contrller: Intel Corp. 82810 CGC [Chipset Graphics Controller] (rev 03) And a few more devices.
I've run dpkg-reconfigure several time and been through all the options, the framebuffers option doesn't make any difference. There are no options in the biso for setting the level of RAM assigned for graphics.
I have a knoppix disk here, and so loaded it, X booted, but I couldn't use the keyboard for some reason. Hence I couldn't look at any of the configuration. As Knoppix worked, I know that it can be done. But as I have already setup the rest of Sarge I don't want to trash it with a knoppix HD install.
Can any one help? James
- -- James Hosken [EMAIL PROTECTED] http://www.jamesho.co.uk GnuPG Key ID: 0x44CB1D77 -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.4 (GNU/Linux) Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFAm7F7/FajwUTLHXcRAsKzAJ9whgYXtNcXNDFAhhXt2al05Ij2RACfdPoZ OfPBWOw+xmIaqX8wTDHkpo4= =TEu8 -----END PGP SIGNATURE-----
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
