I am trying to run a piece of software that apparently depends on a
"RUNNING" message in ifconfig.
dh3:/etc/tss2# /sbin/ifconfig
eth0 Link encap:Ethernet HWaddr 00:E0:18:2A:00:59
inet addr:128.12.19.34 Bcast:128.12.255.255 Mask:255.255.0.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:182004968 errors:0 dropped:0 overruns:0 frame:0
TX packets:107471612 errors:0 dropped:0 overruns:227 carrier:0
collisions:0 txqueuelen:100
RX bytes:2692733011 (2.5 GiB) TX bytes:3770438040 (3.5 GiB)
Interrupt:20
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:10143 errors:0 dropped:0 overruns:0 frame:0
TX packets:10143 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1291706 (1.2 MiB) TX bytes:1291706 (1.2 MiB)
Notice how the loopback interface has "RUNNING" on it, whereas eth0 does
not. It is the lack of RUNNING that is preventing the software I'm
trying to run from loading. It claims that eth0 is NOT running, which,
according to ifconfig, it isn't. What should I do?
-Adar
PS I'm not subscribed to the list, so please respond directly to my
e-mail address
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
