Never mind, I'm an ignorant newbie and forgot to update the inittab file with mgetty for the ports.
Sorry, Barry deFreese NTS Technology Services Manager Nike Team Sports (949)-616-4005 [EMAIL PROTECTED] "Technology doesn't make you less stupid; it just makes you stupid faster." Jerry Gregoire - Former CIO at Dell -----Original Message----- From: deFreese, Barry [mailto:[EMAIL PROTECTED]] Sent: Wednesday, October 16, 2002 1:24 PM To: '[EMAIL PROTECTED]' Subject: Newbie question - Serial Ports Hello, I finally got the ecpa driver for my 8 port Digi board to compile and run. It created the 8 serial devices ttyD000 through ttyD007. I have a modem on port 1 and port 1 or ttyD000 and ttyD001. I installed minicom to see if I could shoot some AT commands to them just to test and I get nada. If I run stty /dev/ttyD000 -a I do get a bunch of output including the buad rate (9600), however most of the other output I don't understand. Is there a good utility to "test" a serial port and also see how it is configured? The digi driver was supposed to build dpa and ditty, two specific programs for the digiboards but neither was built and I cannot get them to compile seperately. Any ideas? Thank you!! Barry deFreese NTS Technology Services Manager Nike Team Sports (949)-616-4005 [EMAIL PROTECTED] "Technology doesn't make you less stupid; it just makes you stupid faster." Jerry Gregoire - Former CIO at Dell -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
