Hi.
I have ATI RAGE IIc video.
In my XFree86.log I found
(II) ATI(0): Using 8MB linear aperture at 0xe6000000
(!!) ATI(0): Virtual resolutions will be limited to 2047 kB
due to linear aperture size and/or placement of hardware cursor image area
(II) ATI(0): Using block 0 MMIO aperture at 0xE5000400
(II) ATI(0): Using block 1 MMIO aperture at 0xE5000000
(==) ATI(0): Write-combining range (0xe6000000,0x200000)
(II) ATI(0): MMIO write caching enabled
(--) ATI(0): 2048 kB of Pseudo-EDO DRAM detected (using 2047 kB)
(WW) ATI(0): Cannot shadow an accelerated frame buffer
Is it means that I have 2MB (or only use) video memory?
$ lspci -v
VGA compatible controller: ATI Technologies Inc 3D Rage IIC AGP (rev 7a)
(prog-if 00 [VGA])
Subsystem: ATI Technologies Inc: Unknown device 0088
Flags: bus master, stepping, medium devsel, latency 64, IRQ 11
Memory at e6000000 (32-bit, prefetchable) [size=16M]
I/O ports at d000 [size=256]
Memory at e5000000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: <available only to root>
$ cat /proc/mtrr
reg00: base=0x00000000 ( 0MB), size= 64MB: write-back, count=1
How can I set my video memory correctly ?
Thanx.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
