Hi all, I have a new MSI 845G Mobo which is based on the i845G chipset and has the ICH4 bridge on it.
The built in LAN works fine with the standard eepro driver - there's no issue there, but I can't get the sound to work. From what I can find, it should work with either the kernel 810 ac97 driver or the alsa i8x0 ac97 driver. However, when I try and load these modules I get: Intel 810 + AC97 Audio, version 0.21, 05:20:10 Sep 7 2002 PCI: Found IRQ 5 for device 00:1f.5 PCI: Sharing IRQ 5 with 00:1f.3 PCI: Setting latency timer of device 00:1f.5 to 64 i810: Intel ICH4 found at IO 0xdc00 and 0xe000, IRQ 5 i810_audio: Audio Controller supports 6 channels. i810_audio: Primary codec not ready. /lib/modules/2.4.19/kernel/drivers/sound/i810_audio.o: init_module: No such device Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters /lib/modules/2.4.19/kernel/drivers/sound/i810_audio.o: insmod /lib/modules/2.4.19/kernel/drivers/sound/i810_audio.o failed /lib/modules/2.4.19/kernel/drivers/sound/i810_audio.o: insmod i810_audio failed Installation failed. (that's for the kernel module. The Alsa modules give similar errors). I do notice that when the kernel loads I get the following message: Real Time Clock Driver v1.10e Non-volatile memory driver v1.1 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH4: IDE controller on PCI bus 00 dev f9 PCI: Device 00:1f.1 not available because of resource collisions ICH4: (ide_setup_pci_device:) Could not enable device. Now I know that is saying conflicts with 1f.1 where as the sound seems to start at 1f.5. I have tried most things in the BIOS and the only PCI card I now have in there is my SCSI card which I really can't remove! Does anyone have any pointers on this one at all? -- Matthew Sackman Nottingham England BOFH Excuse Board: Someone was smoking in the computer room and set off the halon systems. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
