found 408738 1:2.3.1-5 thanks On Sun, Jan 28, 2007 at 01:35:41AM +0100, Kurt Roeckx wrote: > I've tried to change all options I could find to say milimeter instead of > inches, and it was still showing me places where the length is shown in > inches. In the dialog options dialog itself it doesn't change until I > close it and reopen it. and there isn't something like an apply button. > For other dialogs it seems that I need to the application before it > actually changes.
It seems this part is solved as far as I can see, but I didn't look very hard. > I also think there are way to many places where I have to change that > setting. I've changed 6 settings so far. I can still find atleast 6 options where I can change it. > I've changed the rules to show in mm too, and it's showing every 7 mm, > which is rather strange. Since 2.3 this defaulted to inches again, while I've set it to mm before. It's now showing it every 5 mm, which is atleast a little better. It would be nice if I could actually select other options for it. > There also seem to be various rounding issues. If I type 5 mm, it will > show me 5.00 mm in the dialog, but when I close it, and then reopen it > it shows up as 4.99 mm. Still the same. > Also, the measurements of for instance A4 paper shows up as 209.99 / > 296.99 instead of 210 / 297. Still the same. Kurt -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
