Hi,
On Sat, Jun 25, 2011 at 01:38:13PM +0200, Geert Stappers wrote:
> On Thu, Jun 23, 2011 at 09:51:13AM +0200, Johannes Schauer wrote,
> > Use this to produce a directory tree of shared libraries you put in
> > /etc/qemu-binfmt/arm/.
> I still understand that, could it be elaborated? What needs to be in
> /etc/qemu-binfmt/arm/ on the build host? How to achieve that?
I was supplying a multistrap config. You need to run multistrap like
this:
multistrap -a armel -d ./binfmtroot -f multistrap.conf
when multistrap is done, copy the root over to /etc/qemu-binfmt/arm/
sudo rm -rf /etc/qemu-binfmt/arm
sudo cp -r ./binfmtroot /etc/qemu-binfmt/arm
> How should I read that to get a working polystrap?
> (Is "multiarch" another way to reach the same goal?)
multiarch will allow you to `apt-get install` armel shared libraries
even if your host is not armel.
cheers, josch
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive: http://lists.debian.org/20110625174016.GA10039@hoothoot
