hmm, looks like it is complaining about the OpenGL dev libraries- I'll install and try again...
-Ted On Friday 28 October 2005 12:24, Ted Kisner wrote: > I installed the build-deps and ran dpkg-buildpackage. It died for me as > well. The output is attached. > > -Ted > > On Friday 28 October 2005 11:44, Leopold Palomo Avellaneda wrote: > > A Divendres 28 Octubre 2005 19:10, Steve M. Robbins va escriure: > > > Hello, > > > > > > On Fri, Oct 28, 2005 at 06:16:24PM +0200, Leopold Palomo Avellaneda wrote: > > > > I have updated and upgrade today, and I have installed geomview: > > > > ii geomview 1.8.1-9 interactive geometry viewing program > > > > > > > > I'm using Nvidia driver well configured and no graphics problem I > > > > have by now. > > > > > > > > > > > > If I open geomview, I have this messages: > > > > > > [ ... ] > > > > > > Thanks Leopold and thanks also to Larry Doolittle who sent me a > > > similar message, privately. > > > > > > The messages you quote are definitely from the geomview source. > > > However, the binary you used was built over a month ago. Would it be > > > too much trouble for you to do the following? > > > > > > 1. apt-get source geomview > > > 2. build a new deb with current libs and compiler tool chain > > > 3. install and run new geomview > > > > well, I don't have much time now, but I have problem building the > > packege: I have done 1 > > and 2 with: > > > > $~/linux/debian/packages-build/geomview-1.8.1$ fakeroot dpkg-buildpackage > > -us -uc -b > > > > ..... > > > > and after some messages I have this: > > > > > > configure: exit 1 > > /usr/bin/make ACLOCAL="`pwd`/missing aclocal" AUTOCONF="`pwd`/missing > > autoconf" AUTOMAKE="`pwd`/missing automake" AUTOHEADER="`pwd`/missing > > autoheader" moduledir=/usr/lib/geomview > > geomdatadir=/usr/share/geomview/data make[1]: Entering directory > > `/home/leo/linux/debian/packages-build/geomview-1.8.1' > > make[1]: *** No targets specified and no makefile found. Stop. > > > > What I'm doing wrong? > > > > Leo -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
