Package: base
Severity: important
Tags: squeeze
I'm using this network configuration for IPv6 + bonding, but it isn't working
as it should.
I've replaced the IP addresses with xx.xx.xx.xx because this is a private
system.
----
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface (IPv4)
auto bond0
iface bond0 inet static
address xx.xx.xx.xx
netmask 255.255.255.0
gateway xx.xx.xx.xx
slaves eth0 eth1
bond_mode balance-tlb
bond_miimon 100
bond_downdelay 200
bond_updelay 200
# The primary network interface (IPv6)
iface bond0 inet6 static
address xxxx:xxxx:xxxx:1::1
netmask 64
gateway xxxx:xxxx:xxxx::1
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::2
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::3
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::4
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::5
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::6
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::7
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::8
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::9
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::10
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::11
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::12
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::13
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::14
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::15
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::16
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::17
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::18
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::19
up /sbin/ifconfig bond0 inet6 add xxxx:xxxx:xxxx:1::20
----
When I reboot, everything is pinging besides the additional IPv6 addresses (the
'up /sbin/ifconfig' lines).
When running these lines (without the 'up' bit) on SSH they all start pinging
and work fine.
Besides this, all networking related commands completely break networking and
require a reboot.
When I do '/etc/init.d/networking stop', all networking stops, but the bond0
device stays in ifconfig (not pinging)
When I then do '/etc/init.d/networking start', all devices are added to
ifconfig again, but still nothing pings
When I then do 'ifup bond0', it says 'bond0 is not a configured device'
When I do 'ifconfig bond0 down' it goes down and is gone from ifconfig
When I do 'ifconfig bond0 up' it comes back in ifconfig and is not working
So the two problems are that I need to keep rebooting for network changes and
manually adding the additional IPv6 addresses.
-- System Information:
Debian Release: 6.0.2
APT prefers stable
APT policy: (500, 'stable')
Architecture: amd64 (x86_64)
Kernel: Linux 2.6.32-5-amd64 (SMP w/4 CPU cores)
Locale: LANG=en_US.UTF-8, LC_CTYPE=en_US.UTF-8 (charmap=UTF-8)
Shell: /bin/sh linked to /bin/dash
--
To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
