On Sun, Oct 03, 2010 at 04:51:24PM +0000, Debian Bug Tracking System wrote:
> * Make up our mind about which config file to use (fusionforge.conf, not
> gforge.conf) and migrate from gforge.conf if needed (closes: #597916).
> * Ditto for fusionforge-config instead of gforge-config (closes: #597931).
Uh...
# fusionforge-config
bash: fusionforge-config: command not found
# man gforge-config | grep fusionforge
fusionforge-config -- Reconfigure FusionForge
fusionforge-config
This manual page documents briefly the fusionforge-config command.
fusionforge-config replaces (or creates) the configuration files found
in /etc/fusionforge with appropriate files derived from standard
fill-in-the-blank
templates (found in /usr/share/fusionforge/templates). The values used
to fill in the blanks are taken from /etc/fusionforge.conf.
I think it wasn't yet fixed in gforge-common 5.0.2-1 :-/
Thanks in advance.
Best regards,
--
To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
